ISO INTERNATIONAL STANDARD 5347-18 First edition 1993-12-15 Methods for the calibration of vibration and shock pick-ups Part 18: Testing of transient temperature sensitivity Méthodes pour I'étalonnage de capteurs de vibrations et de chocs - Partie 18: Essai de sensibilité de température transitoire Reference number ISO5347-18:1993(E) ISO 5347-18:1993(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. International Standard ISO 5347-18 was prepared by Technical Committee ISO/TC 108, Mechanical vibration and shock, Sub-Committee SC 3, Use and calibration of vibration and shock measuring instruments. ISO 5347 consists of the following parts, under the general title Methods for the calibration of vibration and shock pick-ups: -Part O:Basic concepts --Part 1:Primary vibration calibration by laser interferometry --- Part 2:Primary shock calibration by light cutting -Part3:Secondaryvibrationcalibration Part 4: Secondary shock calibration Part 5:Calibration by Earth's gravitation Part 6:Primary vibration calibration at low frequencies - Part 7: Primary calibration by centrifuge - Part 8: Primary calibration by dual centrifuge ISO1993 mission in writing from the publisher. International OrganizationforStandardization Case Postale 56 · CH-1211 Geneve 20 · Switzerland Printed in Switzerland ii ISO5347-18:1993(E) Part 9: Secondary vibration calibration by comparison of phase an- gles Part 10:Primary calibration byhigh-impact shocks Part 11: Testing of transverse vibration sensitivity .-- Part 12: Testing of transverse shock sensitivity Part 13: Testing of base strain sensitivity -- Part 14: Resonance frequency testing of undamped accelerometers onasteelblock - Part 15: Testing of acoustic sensitivity - Part 16: Testing of mounting torque sensitivity - Part 17: Testing of fixed temperature sensitivity --- Part 18: Testing of transient temperature sensitivity - Part 19: Testing of magnetic field sensitivity - Part 20: Primary vibration calibration by the reciprocity method