INTERNATIONAL ISO/IEC STANDARD 9995-5 Third edition 2009-10-15 Information technology Keyboard layouts for text and office systems Part 5: Editing and function section Technologies de I'informationDisposition des claviers concuspourla bureautique Partie5:Moduled'éditionetdefonctions Reference number ISO/IEC 9995-5:2009(E) IEC Iso ISO/IEC2009 ISO/IEC9995-5:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the fle; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT ISO/IEC2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ISO/IEC2009-AILri ISO/IEC9995-5:2009(E) Contents Page Foreword 1 Scope 2 Conformance 3 Normativereferences 4 Terms and definitions . 5 Arrangement and location... 6 Division into zones. 7 Cursor zone arrangement and location 7.1 "Cross" arrangement . 7.2 "Inverted T" arrangement 8 Functions of the cursor zone. 9 Allocation of the cursor control functions... 9.1 "Cross" layout ... 9.2 "Inverted T" layout .... 10 Arrangement and location of the editing and function zone . ?1S0/IEC2009