ISO INTERNATIONAL STANDARD 10889-5 Second edition 2016-03-15 Tool holders with cylindrical shank Part 5: Type D with more than one rectangular seat Porte-outil a queue cylindrique- Partie 5: Porte-outil de type D comportant plusieurs logements Reference number IS0 10889-5:2016(E) ISO @ IS0 2016 Not forR 001, User=peng, Lu ed without license from IHS IS0 10889-5:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS02016,PublishedinSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 [email protected] www.iso.org @ IS0 2016 - All rights reserved by IHS und No reprodu etworking permitted without license from IHS IS0 10889-5:2016(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Dimensions. 4 Geometrical tolerances ..3 5 Designation 3 6 Technical delivery conditions 6.1 General. .4 6.2 Design 6.3 Scope of delivery ..4 Annex A (informative) Relationship between designations in this part of Is0 10889 and IS0 13399 .5 Bibliography 6 Copyriotnteatioal orzIS0i2harazall rights reserved iii d by IHS under se with ISt thout license from IHS Not for R 001,User=peng,Lu