INTERNATIONAL ISOIASTM STANDARD 51026 First edition 2015-07-15 Practice for using the Fricke dosimetry system Pratique pour I'utilisation du systeme dosimétrique de Fricke Reference number ISO/ASTM 51026:2015(E) So International Organization for Standardization INTER No reproc rom IHS ISO/ASTM 51026:2015(E) ISO/ASTMInternational2015 Al rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or IsO's member body in the country of the requester. In the United States, such requests should be sent to ASTM International. ISO copyright office ASTM International,10o Barr Harbor Drive, PO Box C70o, Casepostale56·CH-1211Geneva20 West Conshohocken, PA 19428-2959, USA Tel. +41 22 749 01 11 Tel. +610 832 9634 Fax +41 22 749 09 47 Fax+6108329635 E-mail [email protected] E-mail [email protected] Web www.iso.org Web www.astm.org Published in Switzerland ntemationalganiiionforStandadization Hicense-zhejang @s/Mzdnteational 2015 - All rights reserved No reproduc ction or networking permitted without icense from IHS ISO/ASTM 51026:2015(E) Contents Page Scope.. 1 2 Referenceddocuments 3 Terminology .... 2 4 Significance and use 2 5 Effect of influence quantities. 2 6 Interferences.. 2 Apparatus. 3 8 Reagents. 3 9 Preparation of dosimeters.... 3 10 Calibration of the dosimetry system 4 11 Application of dosimetry system 5 12 Minimum documentation requirements 9 13 Measurement uncertainty. 9 14 Keywords. 6 Intemational org@iS@kAsTddlbaternational 2015 - All rights reserved indardization 5956617 ili No reproc